Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-82
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
switchport promiscuous-mode
switchport promiscuous-mode
To configure the promiscuous-mode in Gigabit Ethernet interfaces, use the switchport
promiscuous-mode command in interface configuration submode. Use the no form of the command to
delete the configured switch port information.
switchport promiscuous-mode {off | on}
no switchport promiscuous-mode
Syntax Description
Defaults Disabled
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the switch(config-if)# submode for Gigabit Ethernet interfaces.
Examples The following example enables promiscuous mode on a Gigabit Ethernet interface.
switch# config terminal
switch(config)# interface gigabitethernet 8/1
switch(config-if)# switchport promiscuous-mode on
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# switchport promiscuous-mode off
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# no switchport promiscuous-mode
Related Commands
off Disables promiscuous mode.
on Enables promiscuous mode.
Release Modification
1.1(1) This command was introduced.
Command Description
show interface
gigabitethernet
Displays an interface configuration for a specified Gigabit Ethernet
interface.