Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
8-87
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fspf hello-interval
fspf hello-interval
To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use
the no form of the command.
fspf hello-interval seconds vsan vsan-id
no fspf hello-interval seconds vsan vsan-id
Syntax Description
Defaults 20 seconds
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the switch(config-if)# submode.
This command configures FSPF for the specified FCIP interface.
Note This value must be the same in the ports at both ends of the ISL.
Examples The following example configures a hello interval of 3 seconds on VSAN 1.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf hello-interval 3 vsan 1
Related Commands
hello-interval seconds Specifies the FSPF hello-interval in seconds. The rage is 2 to 65535.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
1.1(1) This command was introduced.
Command Description
show fspf interface Displays information for each selected interface.
show interface fcip Displays an interface configuration for a specified FCIP interface.