Send documentation comments to mdsfeedback-doc@cisco.com
11-88
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi enable module
iscsi enable module
To enable iSCSI features for each IPS linecard to create corresponding iSCSI interfaces, use the iscsi
enable module command.
iscsi enable module module-num
Syntax Description
Defaults iSCSI interfaces are disabled on IPS linecards by default.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to enable the iSCSI interface on a desired module number on the
switch.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# iscsi enable module 1
Note The iSCSI feature must be enabled before executing this command.
Related Commands
module-num Specifies the desired IPS linecard module number on which iSCSI interfaces
need to be enabled.
Release Modification
3.2(1) This command was introduced.
Command Description
iscsi enable Enables the iSCSI features but does not create the interfaces.
To Next Page
Loading...
Need help?
General