Send documentation comments to mdsfeedback-doc@cisco.com
8-10
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fabric-membership
fabric-membership
To configure a node to a fabric, use the fabric-membership command. To remove the node from the
fabric, use the no form of the command,
fabric-membership fabric name
no fabric-membership fabric name
Syntax Description
Defaults None.
Command Modes Cisco SME cluster node configuration submode.
Command History
Usage Guidelines Use the fabric-membership command to put a node in a fabric.
This command has to be configured before the interface sme slot/port [force] can be accepted. It also
cannot be removed if the interface sme slot/port [force] command is enabled.
Examples The following example specifies a fabric to which the node belongs :
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# node local
switch(config-sme-cl-node)# fabric-membership f1
Related Commands
fabric name Specifies the fabric name. The maximum length is 32 characters.
Release Modification
3.2(2) This command was introduced.
Command Description
interface sme slot/port [force] Configures the Cisco SME interface to a cluster.
shutdown Enables or disables an interface.
show interface sme Displays interface information.
To Next Page
Loading...
