Send documentation comments to mdsfeedback-doc@cisco.com
23-50
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tlport alpa-cache
tlport alpa-cache
To manually configure entries in an ALPA cache, use the tlport alpa-cache command
tlport alpa-cache interface interface pwwn pwwn alpa alpa
no tlport alpa-cache interface interface pwwn pwwn
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines Generally, ALPA cache entries are automatically populated when an ALPA is assigned to a device. Use
this command only if you wish to manually add further entries.
Examples The following example configures the specified pWWN as a new entry in this cache
switch# config terminal
switch(config)# tlport alpa-cache interface fc1/2 pwwn 22:00:00:20:37:46:09:bd alpa 0x02
Related Commands
interface interface Specifies a Fibre Channel interface.
pwwn pwwn Specifies the peer WWN ID for the ALPA cache entry.
alpa alpa Specifies the ALPA cache to which this entry is to be added.
Release Modification
1.3(5) This command was introduced.
Command Description
show tlport Displays TL port information.
To Next Page
Loading...
Need help?
General