Send documentation comments to mdsfeedback-doc@cisco.com
11-118
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
isns profile name
isns profile name
To create an Internet Storage Name Service (iSNS) profile and enter iSNS profile configuration
submode, use the isns profile name command in configuration mode. To delete the iSNS profile, use
the no form of the command.
isns profile name profile-name
no isns profile name profile-name
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines To use this command, iSNS must be enabled using the isns-server enable command.
Examples The following example shows how to specify an iSNS profile name and enter iSNS profile configuration
submode.
switch# config terminal
switch(config)# isns profile name UserProfile
switch(config-isns-profile)#
Related Commands
profile-name Specifies the profile name. Maximum length is 64 characters.
Release Modification
1.3(1) This command was introduced.
Command Description
server Configures a server IP address in an iSNS profile.
show isns Displays iSNS information.
To Next Page
Loading...
Need help?
General