Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-175
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ipv6 interface
show ipv6 interface
To display IPv6 interface status and configuration information, use the show ipv6 interface command.
show ipv6 interface [gigabitethernet slot/port | mgmt 0 | port-channel port-channel-number |
vsan vsan-id]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displaysIPv6 interface information.
switch# show ipv6 interface
GigabitEthernet1/2 is up
IPv6 is enabled
Global address(es):
5000::1/64
Link-local address(es):
fe80::205:30ff:fe01:a6bf
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
Stateless autoconfig for addresses disabled
GigabitEthernet2/2 is up
IPv6 is enabled
Global address(es):
6000::1/64
Link-local address(es):
fe80::205:30ff:fe00:a413
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
gigabitethernet slot/port Displays a Gigabit Ethernet interface.
mgmt 0 Displays the management interface.
port-channel Displays a PortChannel interface.
port-channel-number Specifies the PortChannel number. The range is 1 to 128.
vsan Displays an IPFC VSAN interface.
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
3.1(0) This command was introduced.