Send documentation comments to mdsfeedback-doc@cisco.com
20-27
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rmon event
rmon event
To configure a remote monitoring (RMON) event, use the rmon event command in configuration mode.
To delete an RMON event, use the no form of the command.
rmon event event-number [description text [owner owner-name] | log [trap community-string]
[description text] [owner owner-name] | trap community-string [description text] [owner
owner-name] | owner owner-name]
no rmon event event-number
Syntax Description
Defaults Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines You can trigger the events created by this command with alarms configured using the rmon alarm or
rmon hcalarm commands
The log option logs the event to a local log file on the MDS switch. The trap option uses the onboard
SNMP agent to send an SNMP trap to a remote NMS.
Note Events can be used by both rmon alarm (32-bit) and hcalarm (64-bit) commands.
Examples The following example configures RMON event 2 to log the onboard RMON log and send an SNMP trap
to public community trap destinations. The description is CriticalErrors and is owned by test.
switch# config terminal
switch(config)# rmon event 2 log trap public description CriticalErrors owner test
event-number Specifies the RMON event number. The range is 1 to 65535.
description text (Optional) Specifies a description of the event. Maximum length is 80
characters.
owner owner-name (Optional) Specifies an owner for the alarm. Maximum length is 80
characters
log (Optional) Generate an RMON log entry in the onboard RMON log when the
event is triggered by an alarm.
trap community-string (Optional) Generate an SNMP trap with the specified community name when
the event is triggered by an alarm. The maximum length is 32 characters.
Release Modification
2.0(x) This command was introduced.
To Next Page
Loading...
Need help?
General