Send documentation comments to mdsfeedback-doc@cisco.com
8-78
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
flex-attach virtual-pwwn auto
flex-attach virtual-pwwn auto
To enable the FlexAttach virtual port WWN (pWWN) on a specific interface, use the flex-attach
virtual-pwwn auto command. To disable the virtual pWWN, use the no form of the command.
flex-attach virtual-pwwn auto [interface auto interface-list]
no flex-attach virtual-pwwn auto [interface auto interface-list]
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines The NPV switch assigns the virtual pWWNs to the interface on which FlexAttach is enabled.
Examples The following example shows how to enable FlexAttach virtual pWWN on a interface.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch#(config)# flex-attach virtual-pwwn auto interface fc 1/1
Related Commands
interface auto
interface-list
Specifies the interface list on which FlexAttach virtual pWWN should be
enabled.
Note All interfaces in the interface-list value must be in the shut mode. If
the interface-list value is not provided, then all ports must be in the
shut mode.
Release Modification
3.3(1a) This command was introduced.
Command Description
flex-attach
virtual-pwwn
interface
Sets the user-specific FlexAttach virtual pWWN.
To Next Page
Loading...
Need help?
General