Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-180
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ipv6 traffic
show ipv6 traffic
To display IPv6 protocol statistics for the system, use the show ipv6 traffic command.
show ipv6 traffic [interface {gigabitethernet slot/port | mgmt 0 | port-channel number | vsan
vsan-id}]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays IPv6 protocol statistics on the system.
switch# show ipv6 traffic
IPv6 Statistics:
Rcvd: 1 total, 0 local destination
0 errors, 0 truncated, 0 too big
0 unknown protocol, 0 dropped
0 fragments, 0 reassembled
0 couldn't reassemble, 0 reassembly timeouts
Sent: 0 generated, 0 forwarded 0 dropped
0 fragmented, 0 fragments created, 0 couldn't fragment
ICMPv6 Statistics:
Rcvd: 0 total, 0 errors, 0 unreachables, 0 time exceeded
0 too big, 0 param probs, 0 admin prohibs
0 echos, 0 echo reply, 0 redirects
0 group query, 0 group report, 0 group reduce
0 router solicit, 0 router advert
0 neighbor solicit, 0 neighbor advert
Sent: 74 total, 0 errors, 0 unreachables, 0 time exceeded
0 too big, 0 param probs, 0 admin prohibs
0 echos, 0 echo reply, 0 redirects
0 group query, 53 group report, 0 group reduce
interface Displays the IP interface status and configuration.
gigabitethernet slot/port Displays a Gigabit Ethernet interface slot and port number.
mgmt 0 Displays the management interface.
port-channel number Dispalsy the PortChannel interface. The range is 1 to 256.
vsan vsan-id Displays a IPFC VSAN interface and specifies the VSAN ID. The range is
1 to 4093.
Release Modification
3.1(0) This command was introduced.