Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
5-4
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 D Commands
deadtime (tacacs+ group configuration)
deadtime (tacacs+ group configuration)
To configure a periodic time interval where a nonreachable (nonresponsive) TACACS+ server is
monitored for responsiveness, use the deadtime command in TACACS+ group configuration submode.
To disable the monitoring of the nonresponsive server, use the no form of the command.
deadtime time
no deadtime time
Syntax Description
Defaults Zero.
Command Modes TACACS+ group configuration submode.
Command History
Usage Guidelines If the dead time interval for an individual TACACS+ server is greater than zero (0), that value takes
precedence over the value set for the server group.
When the dead time interval is 0 minutes, TACACS+ server monitoring is not performed unless the
TACACS+ server is part of a server group and the dead time interval for the group is greater than 0
minutes.
Examples The following example shows the deadtime command in TACACS+ group configuration submode.
switch# config terminal
switch(config)# aaa group server tacacs mygroup
switch(config-tacacs)# deadtime 5
Related Commands
time Specifies the time interval (in minutes) for monitoring the server. The time
range is 1 to 1440 minutes.
Release Modification
3.0(1) This command was introduced.
Command Description
tacacs-server
deadtime
Sets a time interval for monitoring a nonresponsive TACACS+ server.
show tacacs-server Displays TACACS+ server information.