Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-52
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
span session source interface
span session source interface
To configure the SPAN traffic in both ingress (rx) and egress (tx) directions, use the span session source
interface command in Configuration mode.
span session session-id source interface interface type
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines None.
Examples The following example shows how to configure the SPAN traffic in both ingress and egress directions.
switch#config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# span session 1
switch(config-span)# source interface fc 1/5 rx
switch(config-span)# source interface fc 1/5 tx
switch(config-span)# destination interface fc 1/5
Related Commands
session-id Specifies the SPAN session ID.
interface type Specifies the destination interface mapped to a Fiber Channel or FC tunnel.
Release Modification
1.0(x) This command was introduced.
3.3(1a) Enabled SPAN traffic in both ingress (rx) and egress (tx) directions for
Generation 2 Fabric Switches.
Command Description
show span session Displays specific information about a Switched Port Analyzer (SPAN)
session.