Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-47
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rspan-tunnel
rspan-tunnel
To associate and bind the SPAN tunnel (ST) port with the RSPAN tunnel, use the rspan-tunnel
command.
rspan-tunnel interface fc-tunnel tunnel-id
rspan-tunnel
Syntax Description
Defaults None.
Command Modes Interface configuration submode.
Command History
Usage Guidelines The interface is not operationally up until the Fibre Channel tunnel mapping is configured in the source
and destination switches.
Examples The following example configures an interface to associate and bind the ST port with the RSPAN tunnel
and enables traffic flow trough this interface..
switchS# config t
switchS(config)# interface fc2/1
switchS(config-if)# rspan-tunnel interface fc-tunnel 100
switchS(config-if)# no shutdown
rspan-tunnel Configures the remote SPAN (RSPAN) tunnel.
interface Specifies the interface to configure this tunnel.
fc-tunnel tunnel-id Specifies the FC tunnel interface. The range is 1 to 255.
Release Modification
1.2(1) This command was introduced.