Send documentation comments to mdsfeedback-doc@cisco.com
20-15
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
reload
reload
To reload the entire switch, an active supervisor module, a standby supervisor module, or a specific
module, or to force a netboot on a given module, use the reload command in EXEC mode.
reload [module module-number force-dnld]
Syntax Description
Defaults Reboots the entire switch.
Command Modes EXEC mode.
Command History
Usage Guidelines Use the reload command to reboot the system, or to reboot a specific module, or to force a netboot on a
specific module. The reload command used by itself, powers down all the modules and reboots the
supervisor modules.
Use the reload module module-number command, if the given slot has a module or standby supervisor
module, to power-cycle that module. If the given slot has an active supervisor module, then it causes the
currently active supervisor module to reboot and the standby supervisor module becomes active.
The reload module module-number force-dnld command is similar to the previous command. This
command forces netboot to be performed. If the slot contains a module, then the module netboots with
the latest firmware and updates its corresponding flash with this image.
Examples The following example uses reload to reboot the system.
switch# reload
This command will reboot the system. (y/n)? y
The following example uses reload to initiate netboot on a specific module.
switch# reload module 8 force-dnld
The following example uses reload to reboot a specific module.
switch# reload module 8
reloading module 8 ...
The following example uses reload to reboot an active supervisor module.
switch# reload module 5
This command will cause supervisor switchover. (y/n)? y
module module-number Reloads a specific module or active/standby supervisor module.
force-dnld Reloads, initiates netboot, and forces the download of the latest module
firmware version to a specific module.
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
Need help?
General