Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
27-20
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone-attribute-group rename
zone-attribute-group rename
To rename a zone attribute group, use the zone-attribute-group rename command in configuration
mode.
zone attribute group rename current-name new-name vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to rename a zone attribute group.
switch# config terminal
switch(config)# zone-attribute-group rename Group1 Group2 vsan 10
Related Commands
current-name Specifies the current zone attribute name. Maximum length is 64 characters.
new-name Specifies the new zone attribute name. Maximum length is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.0(x) This command was introduced.
Command Description
show zone-attribute-group Displays zone attribute group information.