Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
6-62
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ipacl
debug ipacl
To enable IP access control list (ACL) debugging, use the debug ipacl command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug ipacl {all | error | event | trace}
no debug ipacl {all | error | event | trace}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ipacl all command is issued:
switch# debug ipacl all
Related Commands
all Enables debugging for all IP ACL features.
error Enables debugging for IP ACL error conditions.
event Enables debugging for the IP ACL events.
trace Enables debugging for IP ACL trace.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show ip access-list Displays the IP access control lists that are currently active.