Send documentation comments to mdsfeedback-doc@cisco.com
6-6
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug bootvar
debug bootvar
To enable debugging for boot variables, use the debug bootvar command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug bootvar {all | errors | events | info | pss}
no debug bootvar {all | errors | events | info | pss}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug bootvar all command is issued:
switch# debug bootvar all
Related Commands
all Enables all boot variable debug options.
errors Enables debugging for boot variable errors.
events Enables debugging for boot variable events.
info Enables debugging for boot variable information.
pss Enables debugging for boot variable PSS operations.
Release Modification
1.0(2) This command was introduced.
Command Description
debug all Enables debugging for all features on the switch.
show boot Displays the boot variables or modules.
To Next Page
Loading...
Need help?
General