Send documentation comments to mdsfeedback-doc@cisco.com
22-335
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show sprom
show sprom
To display vendor ID, product component attributes, serial number information that can be used to track
field replacable units, use the show sprom command.
show sprom {backplane backplane-index |
clock clock-module-index |
fan |
mgmt-module |
module module-number sprom-index |
powersupply powersupply-index |
sup}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Command Description
span session source
interface
Configures the SPAN traffic in both ingress (rx) and egress (tx) directions.
backplane
backplane-index
Displays attributes that can be used to uniquely identify a switch. The range
is 1 to 2.
clock
clock-module-index
Displays attributes of the clock module. There are two clock modules in a
switch. This module is absent in MDS9216 type switch. The range is 1 to 2.
fan Displays attributes that uniquely identified fan.
mgmt-module Displays attributes of management module. This module is only present in
MDS9216 type switch.
module module-number
sprom-index
Displays Vendor ID, product's component attributes for the given switching
module. There can be up to 4 sub-components in a module. Each of them
will have a SPROM associated with it.
powersupply
powersupply-index
Displays attributes of the first or the second power-supply. This contains
information about the powersupply capacity in watts when it is used in
110Volts and 220Volts respectively. This information is used for
power-budget allocation. The range is 1 to 2.
sup Displays Vendor ID, product's component attributes for the current
supervisor module
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
Need help?
General