Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-10
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
radius-server retransmit
radius-server retransmit
To globally specify the number of times the switch should try a request with a RADIUS server, use the
radius-server retransmit command. To revert to default value, use the no form of the command.
radius-server retransmit count
no radius-server retransmit count
Syntax Description
Defaults 1 retransmission
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures the number of retransmissions to 3.
switch# config terminal
switch(config)# radius-server retransmit 3
Related Commands
count Configures the number of times the switch tries to connect to a RADIUS
server(s) before reverting to local authentication. The range is 1 to 5 times.
Release Modification
1.0(2) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.