Send documentation comments to mdsfeedback-doc@cisco.com
11-25
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface fc-tunnel
interface fc-tunnel
To configure a Fibre Channel tunnel and facilitate RSPAN traffic, use the interface fc-tunnel command.
To remove a configured tunnel or revert to factory defaults, use the no form of the command.
interface fc-tunnel number
destination ip-address
explicit-path path-name
source ip-address]
no interface fc-tunnel number
no destination ip-address |
no explicit-path path-name
no source ip-address
no interface fc-tunnel number
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example initiates the FC tunnel (100) in the source switch (switch S).
switch(config)# config terminal
switch(config)# interface fc-tunnel 100
switch(config-if)#
The following example maps the IP address of the source switch (switch S) to the FC tunnel (100).
switchS(config-if)# source 10.10.10.1
The following example maps the IP address of the destination switch (switch D) to the FC tunnel (100).
switch(config-if)# destination 10.10.10.2
number Specifies a tunnel ID range from 1 to 255.
destination ip-address Maps the IP address of the destination switch.
explicit-path path-name Specifies a name for the explicit path. Maximum length is 16 alphanumeric
characters.
source ip-address Maps the IP address of the source switch.
Release Modification
1.2(1) This command was introduced.
To Next Page
Loading...
Need help?
General