Send documentation comments to mdsfeedback-doc@cisco.com
11-142
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr withdraw domain
ivr withdraw domain
To withdraw overlapping virtual domain from a specified VSAN, use the ivr withdraw domain
command in EXEC mode.
ivr withdraw domain domain-id vsan vsan-id
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines When you enable the ivr virtual-fcdomain-add command, links may fail to come up due to overlapping
virtual domain identifiers. If so, temporarily withdraw the overlapping virtual domain from that VSAN
using the ivr withdraw domain command in EXEC mode.
Examples The following command withdraws overlapping domains.
switch# ivr withdraw domain 10 vsan 20
Related Commands
domain-id Specifies the domain id. The range is 1 to 239.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
1.3(4) This command was introduced.
Command Description
show ivr virtual-fcdomain-add-status Displays the configured VSAN topology for a fabric.
To Next Page
Loading...
Need help?
General