Send documentation comments to mdsfeedback-doc@cisco.com
22-166
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips stats
show ips stats
To display IP storage statistics, use the show ips stats command.
show ips stats {buffer | dma-bridge | icmp | ip | mac} interface gigabitethernet slot/port
show ips stats {hw-comp | tcp} {all | interface gigabitethernet slot/port}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Use the show ips stats icmp interface gigabitethernet command to obtain ICMP statistics for the
selected interface.
Use the show ips stats ip interface gigabitethernet 2/1 command to obtain IP statistics for the selected
interface.
Use the show ips stats mac interface gigabitethernet command to obtain Ethernet statistics for the
selected interface.
Use the show ips stats tcp interface gigabitethernet command to obtain TCP stats along with the
connection list and TCP state or the selected interface.
Examples The following example displays iSCSI buffer statistics.
switch# show ips stats buffer interface gigabitethernet 1/2
Buffer Statistics for port GigabitEthernet1/2
Mbuf stats
164248 total mbufs, 82119 free mbufs, 0 mbuf alloc failures
123186 mbuf high watermark, 20531 mbuf low watermark
buffer Displays IP storage buffer information.
dma-bridge Displays the direct memory access (DMA) statistics.
icmp Displays ICMP statistics.
ip Displays IP statistics.
mac Displays MAC statistics.
hw-comp Displays hardware compression statistics.
tcp Displays TCP statistics
all Displays statistical information for all interfaces.
interface gigabitethernet
slot/port
Specifies a Gigabit Ethernet interface by the slot and port.
Release Modification
1.1(1) This command was introduced.
To Next Page
Loading...
Need help?
General