Send documentation comments to mdsfeedback-doc@cisco.com
20-39
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rscn abort vsan
rscn abort vsan
To cancel a Registered State Change Notification (RSCN) configuration on a VSAN, use the rscn abort
vsan command in configuration mode. To reverse the cancellation, use the no form of the command.
rscn abort vsan vsan-id
no rscn abort vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example cancels an RSCN configuration on VSAN 1.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# rscn abort vsan 1
Related Commands
vsan-id Specifies a VSAN where the RSCN configuration should be cancelled. The
ID of the VSAN is from 1 to 4093.
Release Modification
3.0(1) This command was introduced.
Command Description
rscn commit vsan Commits a pending RSCN configuration on a specified VSAN.
rscn distribute Enables the distribution of an RSCN configuration.
rscn event-tov Configures an RSCN event timeout.
clear rscn session vsan Clears the RSCN session for a specified VSAN.
show rscn Displays RSCN configuration information.
To Next Page
Loading...
Need help?
General