Send documentation comments to mdsfeedback-doc@cisco.com
2-26
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
auto-volgrp
auto-volgrp
To configure the automatic volume grouping, use the auto-volgrp command. To disable this feature, use
the no form of the command.
auto-volgrp
no auto-volgrp
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Cisco SME cluster configuration submode.
Command History
Usage Guidelines If Cisco SME recognizes that the tape’s barcode does not belong to an existing volume group, then a new
volume group is created when automatic volume grouping is enabled.
Examples The following example enables automatic volume grouping:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# auto-volgrp
switch(config-sme-cl)#
The following example disables automatic volume grouping:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# auto-volgrp
switch(config-sme-cl)#
Related Commands
Release Modification
3.2(2) This command was introduced.
Command Description
show sme cluster Displays Cisco SME cluster information.
To Next Page
Loading...
Need help?
General