Send documentation comments to mdsfeedback-doc@cisco.com
21-36
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
snmp-server
snmp-server
To configure the SNMP server information, switch location, and switch name, use the snmp-server
command in configuration mode. To remove the system contact information, use the no form of the
command.
snmp-server {community string [group group-name | ro | rw] | contact [name] | location
[location]}
no snmp-server {community string [group group-name | ro | rw] | contact [name] | location
[location]}
Syntax Description
Defaults The default community access is read-only (ro).
Command Modes Configuration mode
Command History
Usage Guidelines None.
Examples The following example sets the contact information, switch location, and switch name.
switch# config terminal
switch(config)# snmp-server contact NewUser
switch(config)# no snmp-server contact NewUser
switch(config)# snmp-server location SanJose
switch(config)# no snmp-server location SanJose
community string Specifies SNMP community string. Maximum length is 32 characters.
group group-name Specifies group name to which the community belongs. Maximum length is
32 characters.
ro Sets read-only access with this community string.
rw Sets read-write access with this community string.
contact Configures system contact.
name Specifies the name of the contact. Maximum length is 80 characters.
location Configures system location.
location Specifies system location. Maximum length is 80 characters.
Release Modification
1.0(3) This command was introduced.
2.0(1b) Added group option.
To Next Page
Loading...
Need help?
General