Send documentation comments to mdsfeedback-doc@cisco.com
21-13
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
sdv abort vsan
sdv abort vsan
To terminate an SDV configuration for a specified VSAN, use the sdv abort vsan command in
configuration mode.
sdv abort vsan vsan-id
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines To use this command, you must enable SDV using the sdv enable command.
Examples The following example shows how to terminate an SDV configuration for a specified VSAN.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv abort vsan 2
Related Commands
abort Terminates the SDV configuration.
vsan vsan-id Specifies the number of the VSAN. The range is 1 to 4093.
Release Modification
3.1(2) This command was introduced.
Command Description
show sdv database Displays the SDV database.
sdv enable Enables SDV.
To Next Page
Loading...
Need help?
General