Send documentation comments to mdsfeedback-doc@cisco.com
23-14
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tape-bkgrp
tape-bkgrp
To configure a crypto tape backup group, use the tape-bkgrp command. Use the no form of this
command to disable this feature.
tape-bkgrp groupname
no tape-bkgrp groupname
Syntax Description
Defaults None.
Command Modes Cisco SME cluster configuration mode submode.
Command History
Usage Guidelines A tape volume group is a group of tapes that are categorized by function. For example, HR1 could be
designated tape volume group for all Human Resources backup tapes.
Adding tape groups allows you to select VSANs, hosts, storage devices, and paths that Cisco SME will
use for encrypted data. For example, adding a tape group for HR data sets the mapping for Cisco SME
to transfer data from the HR hosts to the dedicated HR backup tapes.
Examples The following example adds a backup tape group:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# tape-bkgrp group1
switch(config-sme-cl-tape-bkgrp)#
The following example removes a backup tape group:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# no tape-bkgrp group1
switch(config-sme-cl-tape-bkgrp)#
Related Commands
groupname Specifies the backup tape group.
Release Modification
3.2(2) This command was introduced.
Command Description
clear sme Clears Cisco SME configuration.
show sme cluster Displays information about the Cisco SME cluster
To Next Page
Loading...
Need help?
General