Send documentation comments to mdsfeedback-doc@cisco.com
22-85
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show fc-redirect active-configs
show fc-redirect active-configs
To display all active configurations on a switch, use the show fc-redirect active-configs command.
show fc-redirect active-configs
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command is used to verify that there are no active configurations running on the switch during the
following operations:
• Downgrading from 3.2.1 image (supporting FC-Redirect) to an older image where FC-Redirect is
not supported.
• Decommissioning a local switch.
Note Active configuration implies configurations created by applications running on the current switch or
applications created on remote switches for hosts or targets connected to the local switch.
Examples The following example displays the active configurations running on the switch.
switch# show fc-redirect active-configs
Config#1
==========
Appl UUID = 0x00D8 (ISAPI CFGD Service)
SSM Slot = 2
SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL)
Vt PWWN = 2f:ea:00:05:30:00:71:64
Tgt PWWN = 21:00:00:20:37:38:63:9e (LOCAL)
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
Config#2
==========
Appl UUID = 0x00D8 (ISAPI CFGD Service)
SSM Slot = 2
SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL)
Vt PWWN = 2f:ea:00:05:30:00:71:65
Tgt PWWN = 21:00:00:20:37:18:67:2c
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
This command has no other arguments or keywords.
Release Modification
3.2(1) This command was introduced.
To Next Page
Loading...
Need help?
General