Send documentation comments to mdsfeedback-doc@cisco.com
22-87
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show fc-redirect peer-switches
show fc-redirect peer-switches
To display all the peer switches in the fabric running FC-Redirect, use the show fc-redirect
peer-switches command.
show fc-redirect peer-switches
Syntax Description
Defaults None.
Command Modes EXEC mode
Command History
Usage Guidelines This command is used to verify the fabric state and is used for troubleshooting.
Note To find the switch IP address for the list of switch WWNs, use the show cfs peers command.
Examples The following example displays the peer switches in the fabric running FC-Redirect
switch# show fc-redirect peer-switches
-----------------------------------------------------------------
num Switch WWN State FCR-Ver Cfg-Mode
-----------------------------------------------------------------
1 20:00:00:0d:EC:20:13:00 UP 2 V2
Table 22-3 describes the output for the show fc-redirect peer-switches states.
This command has no arguments or keywords.
Release Modification
3.2(1) This command was introduced.
3.3(1a) Added the FC-Redirect version of the switch and configuration mode to the
command output.
Ta b l e 22-3 Show FC-Redirect Peer Switch States
State Description
Up The peer switch is fully synchronized with the
local switch.
Down The communication with the peer switch is not
available.
Syncing The local switch is synchronizing its
configuration with the peer switch.
Error Connection with peer switch is not available.
To Next Page
Loading...
Need help?
General