Send documentation comments to mdsfeedback-doc@cisco.com
22-310
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show santap module
Related Commands
avt vsan Displays the AVT VSAN number.
cvt id Displays the CVT ID number.
cvt nwwn Displays the CVT Node port world wide name.
cvt pwwn Displays the CVT port world wide name
cvt vsan Displays the CVT VSAN number.
cvt xmap_id Displays the CVT Xmap ID number.
dvt fp_port Displays the DVT fabric port number.
dvt id Displays the DVT
dvt if_index Displays the DVT interface index number.
dvt lun Displays the DVT LUN.
dvt mode Displays the DVT mode.
dvt name Displays the DVT name.
dvt nwwn Displays the DVT Node port world wide name.
dvt pwwn Displays the DVT port world wide name.
dvt vsan Displays the DVT VSAN number.
host pwwn Displays the host port world wide name.
num ranges Displays the number ranges.
rvt id Displays the RVT ID number.
rvt if_index Displays the RVT interface index.
rvt lun Displays the RVT LUN.
rvt nwwn Displays the RVT Node port world wide name.
rvt pwwn Displays the RVT port world wide name.
rvt vsan Displays the RVT VSAN number.
session id Displays the session ID number.
session state Displays the session state.
tgt lun Displays the target LUN.
tgt pwwn Displays the target port world wide name.
tgt vsan Displays the target VSAN number.
vdisk id Displays the virtual disk ID number.
xmap id Displays the Xmap ID number.
Table 22-8 show santap Field Descriptions (continued)
Field Description
Command Description
santap module Configures the mapping between the SSM and the VSAN where the
appliance is configured.
To Next Page
Loading...
Need help?
General