Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-341
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show startup-config
show startup-config
To display the startup configuration file, use the show startup-config command
show startup-config [log]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the switch configuration at startup.
switch# show startup-config
vsan database
vsan 2
vsan 3
vsan 4
vsan 5
vsan 31
vsan 32 suspend
vsan 100
vsan 300
interface port-channel 1
switchport mode E
switchport trunk mode off
interface port-channel 2
fspf cost 100 vsan 2
switchport mode E
no switchport trunk allowed vsan all
switchport trunk allowed vsan add 1-99
switchport trunk allowed vsan add 101-4093
interface port-channel 3
switchport mode E
switchport trunk mode off
interface port-channel 4
switchport mode E
no switchport trunk allowed vsan all
log Displays execution log of last used ASCII startup configuration.
Release Modification
1.0(2) This command was introduced.