Send documentation comments to mdsfeedback-doc@cisco.com
23-25
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
target (iSLB initiator configuration)
The following example grants iSLB initiator access to the target using a device alias and an optional
IQN.
switch(config-islb-init)# target device-alias SampleAlias iqn-name
iqn.1987-01.com.cisco.initiator
The following example grants iSLB initiator access to the target using a device alias and a VSAN
identifier.
switch(config-islb-init)# target device-alias SampleAlias vsan 10
Note The VSAN identifier is optional if the target is online. If the target is not online, the VSAN
identifier is required.
The following example disables the configured iSLB initiator target.
switch (config-islb-init)# no target pwwn 26:00:01:02:03:04:05:06
Related Commands Command Description
islb initiator Assigns an iSLB name and IP address to the iSLB initiator and enters
iSLB initiator configuration submode.
show islb initiator Displays iSLB CFS information.
show islb initiator detail Displays detailed iSLB initiator information.
show islb initiator
summary
Displays iSLB initiator summary information.
To Next Page
Loading...
Need help?
General