Send documentation comments to mdsfeedback-doc@cisco.com
8-83
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fspf config vsan
Command History
Usage Guidelines This command configures FSPF on VSANs globally.
For the commands issued in FSPF configuration mode, you do not have to specify the VSAN number
every time. This prevents configuration errors that might result from specifying the wrong VSAN
number for these commands.
Examples The following example configures FSPF globally in VSAN 1, deletes the FSPF configured in VSAN 3,
disables FSPF in VSAN 5, and enables FSPF in VSAN 7.
switch## config terminal
switch(config)##
switch(config)# fspf config vsan 1
switch-config-(fspf-config)# spf static
switch-config-(fspf-config)# exit
switch(config)#
switch(config)# no fspf config vsan 3
switch(config)#
Related Commands
Release Modification
1.0(2) This command was introduced.
Command Description
show fspf interface Displays information for each selected interface.
fspf enable Enables FSPF routing protocol in the specified VSAN (from the
switch(config-if)# prompt).
fspf cost Configures the cost for the selected interface in the specified VSAN (from the
switch(config-if)# prompt).
fspf hello-interval Specifies the hello message interval to verify the health of a link in the VSAN
(from the
switch(config-if)# prompt).
fspf passive Disables the FSPF protocol for the specified interface in the specified VSAN
(from the
switch(config-if)# prompt).
fspf retrasmit Specifies the retransmit time interval for unacknowledged link state updates in
specified VSAN (from the
switch(config-if)# prompt).
To Next Page
Loading...
Need help?
General