Send documentation comments to mdsfeedback-doc@cisco.com
11-78
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ipv6 route
The following example configures a fully specified static route on a Gigabit Ethernet interface.
switch(config)# ipv6 route 2001:0DB8::/32 gigabitethernet 3/2
The following example configures a recursive static route to a specified next hop address.
switch(config)# ipv6 route 2001:0DB8::/32 2001:0DB8:2002::1
The following example configures a recursive static route to a specified next hop address, from which
the output interface is automatically derived, and to a specified interface.
switch(config)# ipv6 route 2001:0DB8::/32 2001:0DB8:2002::1 gigabitethernet 3/2
The following example configures a static IPv6 route with an administrative distance of
20.
switch(config)# ipv6 route 2001:0DB8::/32 interface gigabitethernet 2/0 distance 20
Related Commands ipv6 access-list Configures an IPv6 access control list (ACL) and enters IPv6-ACL
configuration submode.
ipv6 routing Enables IPv6 unicast routing.
show ipv6 access-list Displays a summary of ACLs.
show ipv6 route Displays the static IPv6 routes configured on the switch.
show ipv6 routing Displays the IPv6 unicast routing configured on the switch.
To Next Page
Loading...
Need help?
General