Send documentation comments to mdsfeedback-doc@cisco.com
11-86
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi dynamic initiator
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following command configures the dynamic initiator mode as iSLB.
switch(config)# iscsi dynamic initiator islb
The following command configures the dynamic initiator mode as deny.
switch(config)# iscsi dynamic initiator deny
The following command reverts to the default dynamic initiator mode of iSCSI.
switch(config)# no iscsi dynamic initiator deny
Related Commands Command Description
iscsi save-initiator Permanently saves the automatically-assigned nWWN or pWWN mapping.
show iscsi global Displays global iSCSI configured information.
To Next Page
Loading...
