Send documentation comments to mdsfeedback-doc@cisco.com
14-5
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
line com1
switch# config terminal
switch(config)# line com1
switch(config-com1)# modem set-string user-input ATE0Q0V1&D0&C0S0=1
The following example deletes the configured initialization string.
switch# config terminal
switch(config)# line com1
switch(config-com1)# no modem set-string user-input ATE0Q1&D2&C1S0=3\015
The following example writes the user-specified initialization string to the modem.
switch# config terminal
switch(config)# line com1
switch(config-com1)# modem init-string user-input
Related Commands Command Description
line console Configure primary terminal line.
line vty Configure virtual terminal line.
show line com1 Displays COM1 information.
To Next Page
Loading...
Need help?
General