Send documentation comments to mdsfeedback-doc@cisco.com
15-8
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
member (ivr zone configuration)
member (ivr zone configuration)
To add a member name to an Inter-VSAN Routing (IVR) zone, use the member command in IVR zone
configuration submode. To remove a member name from an fcalias, use the no form of the command.
member {device-alias aliasname {lun lun-id vsan vsan-id autonomous-fabric-id afid |
vsan vsan-id autonomous-fabric-id afid} |
pwwn pwwn-id {lun lun-id vsan vsan-id autonomous-fabric-id afid | vsan vsan-id
autonomous-fabric-id afid}}
no member {device-alias aliasname {lun lun-id vsan vsan-id autonomous-fabric-id afid |
vsan vsan-id autonomous-fabric-id afid} |
pwwn pwwn-id {lun lun-id vsan vsan-id autonomous-fabric-id afid | vsan vsan-id
autonomous-fabric-id afid}}
Syntax Description
Defaults None.
Command Modes IVR zone configuration submode.
Command History
Usage Guidelines You can configure an IVR zone member based on the specified pWWN and LUN value or, based on the
specified pWWN, LUN value, and AFID.
Note The CLI interprets the LUN identifier value as a hexadecimal value whether or not the 0x prefix is
included.
Examples The following example shows how to configures an IVR zone member based on the device alias VSAN,
and the AFID.
device-alias aliasname Specifies the member device alias. Maximum length is 64 characters.
lun lun-id Specifies the member LUN ID. The format is 0xhhhh[:hhhh[:hhhh[:hhhh]]],
where h is a hexadecimal digit.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
autonomous-fabric-id
afid
Specifies the AFID to the local VSAN.
pwwn pwwn-id Specifies the member pWWN ID. The format is hh:hh:hh:hh:hh:hh:hh:hh,
where h is a hexadecimal digit.
Release Modification
1.3(1) This command was introduced.
2.1(1a) Added lun parameter.
To Next Page
Loading...
Need help?
General