Send documentation comments to mdsfeedback-doc@cisco.com
16-3
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 16 N Commands
nasb module
The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 10, and
enables a single target LUN that is a Storage Array Controller (Peripheral Device Type = 0x0C) and up
to 10 target LUNs.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# nasb module 4 vsan 10 control multiple
Related Commands Command Description
ssm enable feature Enables the NASB feature on the Storage Services Module (SSM).
nasb module Displays the NASB configuration on the SSM.
nasb rediscover module Initiates the rediscovery of a target device used for NASB on an SSM
where the feature is enabled.
To Next Page
Loading...
Need help?
General