Send documentation comments to mdsfeedback-doc@cisco.com
22-112
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ficon
Port number is 1, Interface is fc1/1
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255
Port Address 2 is not installed in vsan 2
Port number is 2, Interface is fc1/2
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255
...
Port Address 239 is not installed in vsan 2
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255
Port Address 240 is not installed in vsan 2
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255
The following example displays port address information in a brief format.
switch# show ficon vsan 2 portaddress 50-55 brief
-------------------------------------------------------------------------------
Port Port Interface Admin Status Oper FCID
Address Number Blocked Mode
-------------------------------------------------------------------------------
50 50 fc2/18 on fcotAbsent -- --
51 51 fc2/19 off fcotAbsent -- --
52 52 fc2/20 off fcotAbsent -- --
53 53 fc2/21 off fcotAbsent -- --
54 54 fc2/22 off notConnected -- --
55 55 fc2/23 off up FL 0xea0000
56 55 off up FL 0xea0000
The following example displays port address counter information.
switch# show ficon vsan 20 portaddress 8 counters
Port Address 8(0x8) is up in vsan 20
Port number is 8(0x8), Interface is fc1/8
Version presented 1, Counter size 32b
242811 frames input, 9912794 words
484 class-2 frames, 242302 class-3 frames
0 link control frames, 0 multicast frames
0 disparity errors inside frames
0 disparity errors outside frames
0 frames too big, 0 frames too small
0 crc errors, 0 eof errors
0 invalid ordered sets
0 frames discarded c3
0 address id errors
116620 frames output, 10609188 words
0 frame pacing time
0 link failures
0 loss of sync
0 loss of signal
0 primitive seq prot errors
0 invalid transmission words
1 lrr input, 0 ols input, 5 ols output
0 error summary
The following example displays the contents of the specified FICON configuration file.
To Next Page
Loading...
