Send documentation comments to mdsfeedback-doc@cisco.com
22-260
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show module
Contiguous and aligned indices unavailable for Generation-1 modules
Check "show port index-allocation" for more details
Please follow the steps below:
1. Power-off module in one of the following slots: 12
2. Power-on module in slot 4 and wait till it comes online
3. Power-on the module powered-off in step 1
4. Do "copy running-config startup-config" to save this setting
The following example uses the show module, show port index-allocation, and show module
recovery-steps commands to display a Generation 1 module that is powered down because of alignment,
even though contiguous indices 208 through 252 are available.
switch# show module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 48 1/2/4 Gbps FC Module DS-X9148 ok
2 48 1/2/4 Gbps FC Module DS-X9148 ok
4 48 1/2/4 Gbps FC Module DS-X9148 ok
5 0 Supervisor/Fabric-2 DS-X9530-SF2-K9 active *
6 0 Supervisor/Fabric-2 DS-X9530-SF2-K9 ha-standby
7 48 1/2/4 Gbps FC Module DS-X9148 ok
9 32 1/2 Gbps FC Module DS-X9032 powered-dn
Mod Power-Status Power Down Reason
--- ------------ ---------------------------
9 powered-dn Insufficient resources (dest Index)
switch# show port index-allocation
Module index distribution:
------------------------------------------------------+
Slot | Allowed | Alloted indices info |
| range | Total | Index values |
-----|---------|-------|------------------------------|
1 | 0-1023| 48 | 160-207 |
2 | 0-1023| 48 | 3-50 |
3 | ----- | - | (None) |
4 | 0-1023| 48 | 51-98 |
7 | 0-1023| 48 | 99-146 |
8 | ----- | - | (None) |
9 | ----- | - | (None) |
SUP | 253-255 | 3 | 253-255 |
switch# show module 9 recovery-steps
Failure Reason:
Contiguous and aligned indices unavailable for Generation-1 modules
Check "show port index-allocation" for more details
Recovery Steps:
Please follow the steps below:
1. Power off module in ANY ONE of the slots: 1, 4
2. Power on failed module in slot 9 and wait till it comes online
3. Power on the module that was powered off in step 1 and wait till it comes
online
4. Do "copy running-config startup-config" to save this setting
To Next Page
Loading...
