Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
100 Configuration Manual, 06/2015, C79000-G8976-C406-02
Note
This command is only available with a KEY
-PLUG.
With this command you specify which destination server will be used.
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Call up the command with the following parameters:
logon {idx <num(1-100)> | all} {enabled|disabled}
The parameters have the following meaning:
Keyword for the number of the destina-
-
Number corresponding to a specific
destination server.
Enter the required number.
Uses all destination servers
The specified destination server is enabled.
You display this setting and other information with the show srs overview command.
You create the destination server with the
logon command.
You disable the destination server with the
no logon (disable) command.
You display the numbers of the destination servers with the
logon show-idx command.
To Next Page
Loading...
Need help?
General
