Siemens SCALANCE S615 - Dns; The Show Commands; Show Dnsclient Information

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
207
6.5
DNS
This section describes commands of the Domain Name System (DNS).
6.5.1
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
6.5.1.1
show dnsclient information
Description
This command shows the configuration of the DNS client.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
show dnsclient information
Result
The information is displayed.