Siemens SCALANCE S615 - Safety notices on use in hazardous areas

Configuration
2.1 System
SCALANCE S615 Command Line Interface
48 Configuration Manual, 06/2015, C79000-G8976-C406-02
2.1.5
disable
Description
With this command, you close the Privileged EXEC mode.
You are then in the User EXEC mode.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
disable
Result
You are in the User EXEC mode.
The command prompt is as follows:
cli>
2.1.6
enable
Description
With this command, you change to the Privileged EXEC mode.
Requirement
You are in the User EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
enable