Siemens SCALANCE S615 - No Ip Dhcp-Server Icmp-Probe

Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
194 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the ip dhcp-server command.
6.4.2.3
no ip dhcp-server icmp-probe
Description
With this command, you disable the "Probe address with ICMP Echo before offer" function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server icmp-probe
Result
The function is disabled.
Further notes
You enable the function with the ip dhcp-server icmp-probe command.