Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
430 Configuration Manual, 06/2015, C79000-G8976-C406-02
The settings for monitoring the physical network connections have been configured.
You can display the current setting with the show events faults config command.
You disable the function with the
no link command.
With this command, you disable the monitoring of the physical network connections for cable
breaks or for pulling of the connector.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
no link {up|down}
The parameters have the following meaning:
The message when establishing a connection is
-
The message when a connection is down is disa-
-
The settings for monitoring the physical network connections have been configured.
You can display the current setting with the show events faults config command.
You enable the function with the
link command.
To Next Page
Loading...
Need help?
General
