Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
340 Configuration Manual, 06/2015, C79000-G8976-C406-02
prerule ipsec ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Keyword for the interface
Type or speed of the interface Specify a valid interface.
Interface index Specify a valid interface
index.
Enables the predefined firewall rule on all inter-
-
Enables the predefined firewall rule.
Disables the predefined firewall rule.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
The predefined firewall rule IPSEC is enabled on the relevant interface. IKE (Internet Key
Exchange) data transfer from the external network to the device is allowed.
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
prerule snmp ipv4
Description
With this command, you enable the predefined firewall rule SNMP on the selected interface.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call up the command with the following parameters:
prerule snmp ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
To Next Page
Loading...
Need help?
General
