Siemens SCALANCE S615 - Show Events Faults Status; Show Fault Counter

Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
414 Configuration Manual, 06/2015, C79000-G8976-C406-02
10.1.1.4
show events faults status
Description
This command shows the status messages of fault monitoring of the power supply and
network connections.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events faults status
Result
A table with the status messages of the error monitoring functions is displayed.
10.1.1.5
show fault counter
Description
This command shows the number of errors since the last startup.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show fault counter
Result
The number of faults is displayed.
Further notes
You reset the counter for the errors with the clear fault counter command.