Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
332 Configuration Manual, 06/2015, C79000-G8976-C406-02
The IPv4 firewall rules are listed.
You display the IPv4 firewall rule with the ipv4rule command.
ipv4rule show-rules
Description
With this command, you display the available IPv4 firewall rules.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call the command without parameter assignment:
ipv4rule show-rules
The IPv4 firewall rules are listed.
You display further information with the show firewall ip-rules ipv4 command.
You display the IPv4 firewall rule with the
ipv4rule command.
prerule ipv4 show-int
Description
With this command, you list the available interfaces.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
To Next Page
Loading...
