Siemens SCALANCE S615 - Base Bridge-Mode

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
145
5.1.2.1
base bridge-mode
Description
With this command, you configure whether or not the device forwards frames with VLAN
tags transparently (IEEE 802.1D/VLAN-unaware mode) or takes VLAN information into
account (IEEE 802.1Q/VLAN-aware mode).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
base bridge-mode {dot1d-bridge|dot1q-vlan}
The parameters have the following meaning:
Parameter
Description
Range of values / notes
dot1d-bridge
Sets the mode "VLAN-unaware" for the device.
VLAN tags are not taken into account or
changed but are forwarded transparently.
-
dot1q-vlan
Sets the mode "VLAN-aware" for the device.
VLAN information is taken into account.
-n
Result
The device mode is configured.
Further notes
You display the status of this function and other VLAN information with the show vlan device
info
command.