Siemens SCALANCE S615 - Commands in the IPSEC PHASE2 Configuration Mode; Auto-Fwrules

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
396 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
ike-lifetime <min(10-2500000)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
min
Period for DPD queries Specify the period of time in
minutes.
Result
The period of time is configured.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
9.3.8
Commands in the IPSEC PHASE2 configuration mode
This section describes commands that you can call up in the IPSEC PHASE configuration
mode.
In the IPSEC CONNECTION configuration mode, enter the
phase 2 command to change to
this mode.
● If you exit the IPSEC PHASE2 configuration mode with the
exit command, you return to
the IPSEC CONNECTION configuration mode.
● If you exit the IPSEC PHASE2 configuration mode with the
end command, you return to
the Privileged EXEC mode.
9.3.8.1
auto-fwrules
Description
With this command you specify that the firewall rule will be created automatically for the VPN
connection.